Feeding Hdmi Cable Through Conduit

Use tape to fix the end like you pull wire.

Feeding hdmi cable through conduit.

As you can see despite the sharply bent pipe the cable got through effortlessly. The fish tape may get stuck on the second 90o turn or it may become caught on the previously installed cables. Assembled cable and connector ready for use. A ring of the same size as a drawing wire is made in the feed cable.

Picture showing how much space there is left in a 20mm pipe. Connect the new wires plus two wires. Make a loop in the feed cable the same size as the one in the pull wire. Make a loop small enough that it will easily fit into the conduit then secure the loop by wrapping the free end to the wire strand with tape.

Pass the end of the wire or cable through the ring that you make in the wire. Lubricating the wires. Step 3 pull the wire through the conduit. The first extra wire is to replace the wire being used as a pull string and the second is to be left in the conduit as a pull string for possible later use.

Pulling wires can be difficult enough through straight runs of conduit but throwing a few bends and turns in the run increases friction making pulling much more difficult that s when you use a lubricant. Method 3 pull the pull wire through the conduit. When feeding fish tape through conduit you can run up against some unavoidable obstacles a couple of 90o turns or previously installed cables that make it difficult to push the fish tape through the entire length of conduit. Place your wire box so that it is free to leave the box and freely enter the conduit.

Supra hdmi features. Wire pulling compound is a non conductive lubricant in either a gel or a slimy soapy form that makes both the conduit and wires slick by coating the wiring allowing. Nylon braid is used as an aid to pull the cable through the conduit.